WSPPN Maintains These Topic Hubs
Acetone / Air filters / Air quality / Aqueous cleaning / Benchmarking (Management) / Best management practices / Boatbuilding / Catalysts / Clean Air Act / Cleaning / Cleaning machinery and appliances / Coating processes / Compliance / Composite materials / Compressed air / Corrosion resistant materials / Distillation / Economic analysis / Emission control / Emissions / Fiber reinforced plastics / Fiberglass / Hazardous substances / Hazardous waste / High volume low pressure spray guns / Indiana / Laminated materials / Measurement / Molding (Founding) / Paint / Plastics / Powder coatings / Ships / Shipyards / Solvents / Spray guns / Spraying equipment / Storage tanks / Styrene / Substitute materials / Ventilation / Volatile organic compounds / Waste management / Waste reduction / Water based products
Alphabetical Listing of Reference Documents by Title
NOTE: [PDF] links require Acrobat Reader from Adobe.
Composite Manufacturing Process
Abstract: Describes the two general divisions of composites manufacturing processes: open molding (sometimes called contact molding) and closed molding.
Source: American Composite Manufacturers Association (ACMA)
EPA Sector Notebook: Profile of the Plastic Resins and Man-Made Fibers Industry [PDF]
Abstract: Provides information about process inputs and outputs, and environmental and regulatory implications of these materials and fiberglass processes.
Source: U.S. Environmental Protection Agency
Establishing Waste Reduction Benchmarks and Good Manufacturing Practice for Open Mold Laminating [PDF]
Abstract: This paper illustrates how to use planned experientation to establish benchmarks for good operating practices and cost reductions in a fiberglass laminating facility.
Source: North Carolina Office of Waste Prevention
Fountain Powerboats Incorporated - Process Modification: Equipment Change [PDF]
Abstract: Case study of a fiberglass fabricator that switched from spray guns to vacuum bags to deliver resin to the mold.
Source: Waste Reduction Resource Center
Reports on FRP and Light-RTM Manufacturing Technologies Tested at the Coatings Applications Research Laboratory (CARL)
Abstract: Series of reports on various fiberglass technologies that may reduce emissions and waste related to fiberglass processes.
Source: Coatings Applications Research Laboratory (CARL)
Resin Transfer Molding
Abstract: Resin transfer molding (RTM) is a closed-mold pressure injection system which allows for faster gel and cure times as compared to contact molded parts.
The Topic Hub™ is a product of the Pollution Prevention Resource Exchange (P2Rx)
The Fiberglass Fabrication Topic Hub™ was developed by:
Hub Last Updated: 6/4/2013